Page 1 of 1

Revell 1/144 F-15E

Posted: Tue Jul 07, 2020 9:09 pm
by csnewton2701
Now that the little one is a  bit older and in a settled sleep routine I have decided to get a model out. Its not the usual size but a bit smaller in 1/144 so will see how this one goes.


With 3 larger sprues, 1 medium ad 1 small and a small clear sprue it looks a very tidy kit. At first glance it looks very detailed with plenty of recessed panel lines there but I will have to see how it fits together.


This will be an out of the box build with no aftermarket gear. The decals are small and don't give you a choice of serials but being basic on this size I cant see how you could detail it with the decals.

Image20200705_221323 by Christopher Newton, on Flickr

Image20200705_221346 by Christopher Newton, on Flickr

Image20200705_221404 by Christopher Newton, on Flickr

Image20200705_221414 by Christopher Newton, on Flickr

Image20200705_221425 by Christopher Newton, on Flickr



Chris

Re: Revell 1/144 F-15E

Posted: Wed Jul 08, 2020 7:42 pm
by csnewton2701
Well the first bits are together with only a few minor issues.


The detailing in the cockpit is rather difficult with the size. The decals are small and fiddly and the console, stick and seat are difficult to put in place with no room for movement.


The main section comes in 4 pieces, left and right for the cockpit and nose and a top and bottom for the wings and main fuselage.


I did notice that there is a slight difference in diameter where the nose meets the main body, while leaving a small gap at the top in the join of the left and right sections.


Where the top and bottom sections of the wings meet there is also a small gap.


Other than that, so far so good.

Image20200708_194841 by Christopher Newton, on Flickr

Image20200708_194832 by Christopher Newton, on Flickr

Image20200708_194812 by Christopher Newton, on Flickr

Image20200708_194726 by Christopher Newton, on Flickr


Chris

Re: Revell 1/144 F-15E

Posted: Thu Jul 09, 2020 7:21 pm
by csnewton2701
A little bit more done with relative ease.


Both air intakes went on with a nice fit, the exhausts went on again with no issues and the vertical stabilisers on the tail are both on. This was a little tricky but had no problems, just needed to keep them as straight as I could.

Image20200709_170456 by Christopher Newton, on Flickr

Image20200709_170517 by Christopher Newton, on Flickr

Image20200709_170615 by Christopher Newton, on Flickr


Chris